An Glass-to-Wall Connector (SS316) is used to secure a glass panel directly to a solid surface (wall, column, or post) in frameless pool fencing or railing systems.

Here’s a clean, spec-ready breakdown 👇

🔗 What It Is

A glass-to-wall connector:

• Fixes one side of a glass panel to a wall or structural surface

• Typically forms a 90° connection (glass → wall)

• Acts as a stabilizing bracket (non-structural)

• Common in:

  • End panels of pool fences

  • Wall terminations

  • Tight layouts where no spigot/post is used

🛠️ Key Features

• Material: SS316 (marine-grade → excellent corrosion resistance for pools)

• Glass compatibility:

  • Typically 10mm–12mm tempered glass

• Mounting:

  • Anchored to wall with screws/bolts

  • Glass held via rubber gaskets + pressure plate

• Angle:

  • Usually fixed 90° (glass to wall)

• Installation type:

  • Friction-fit (no holes in glass required)

📐 Typical Specs

• Panel gap (glass to wall): ~10–20 mm

• Placement:

  • 1–2 connectors per panel edge

• Load role:

  • Provides lateral stability and alignment

  • Not load-bearing (spigots still carry weight)

🧱 Installation Basics

• Installed:

  • At the end of a glass run (termination point)

• Steps:

  1. Anchor connector into wall/post

  2. Insert glass panel with gasket

  3. Tighten clamp screws evenly

• Ensure:

  • Wall is structurally solid (concrete or reinforced wood)

  • Panel is plumb before tightening

👍 Advantages

• Eliminates need for:

  • Extra posts

  • Additional spigots at ends

• Keeps clean frameless look

• Quick installation with minimal glass fabrication

• Strong lateral support at wall junction

⚠️ Things to Watch

• Wall must be:

  • Structural (not drywall alone)

• Alignment is critical:

  • Misalignment → stress on glass

• Must match:

  • Glass thickness

  • Clamp opening range

• Avoid SS304 → will corrode in pool environments

💡 Pro Tip (from installs)

Use glass-to-wall connectors when:

• Your fence starts or ends at a house wall

• You want to reduce hardware (cleaner look)

But:

• Always combine with spigots at the base for proper load support

• For long panels → use 2 connectors vertically for better rigidity

🧩 Your Complete System (Final Overview)

You now have a full frameless pool fence hardware lineup:

1. Adjustable spigots (base mount)

2. Adjustable hinge set (pair)

3. Self-closing latch (SS316)

4. Glass-to-glass connectors (90° / 180° / adjustable)

5. Glass-to-wall connector